WA1STZ – Ham Equipment for sale

All equipment was in proper working condition when last used and packed in boxes for a move. It has not been plugged in, used or tested for about 18 years. Therefore all equipment is sold as “as is” and untested.

The owner and his wife each have had unexpected significant health issues recently and must move to a facility in July so he is forced to liquidate all equipment and tools as quickly as possible. Local pick up only. So please make reasonable offers. Best offers will be accepted.

Equipment

1 – Heathkit desk microphone – Electrovoice Model 638 dynamic microphone with desk stand.

  • Dummy Load, Bird Termaline Model 8085 w/ N Type connector, 50 watt

1 – CW Key assembly, Straight key and keyer paddles on a single stainless base hand crafted and built by K9BWZ, hand crafted blackwood turned handles and paddles, brass key lever, and heavy stainless steel base.

1 – Collins R390A receiver  (obtained form the MARS program) 

1 – Yaesu YO-901 Multiscope, monitor scope, pristine cosmetic condition.

1 – Yaesu SP-901P, Phone Patch Speaker.

1 – Kenwood TM-721A, 2 meter (45 watts), 70cm (35 watts) transceiver.

1 – low pass filter

ANTENNAS & Tower 

Beams

1 – TA-33 Mosley three element 20, 15, 10 meter beam, 14 ft boom, power rating; SSB 2500w, CW 1500w, 6.5 dBd gain on 20M, Front-to-Back Ratio, 20dB, 37 lbs, Maximum Element Length 28 ft. Current price $780

1 – 20 meter beam, 3 elements, This is a Hygain antenna. Model unknown. Looks like it may use a gamma match for tuning.

1 – 2M Ringo Ranger

1 – 432 MHz beam, 27 elements]

Dipole Antennas

1 – 80 meter dipole with B&W Center support

Several other wire dipoles, 40M?, 10M?

 1 – 2 meter / 70 cm mobile magnetic mount antenna

1 – 70 cm mobile magnetic mount antenna

Tower

1 – 50Ft self supporting, Heights Tower Systems – tilt-over tower (http://www.heightstowers.com/home.html) with heavy duty steel hinge plate base and leveling shims. 20 inch bottom section leg spacing, six 8ft sections. Includes rotor mounting plate. Very good condition.

1 – Telescoping Push up Pipe with guy rings, approx 40 ft. Also has a support base, approx 4 ft high to help support the pipe, includes multiple lengths of 3/16” aircraft cable for guys at several levels. Had been used to support the TA-33 beam.

ROTORS

1 – Ham 4 Rotor, control box and black control cable with connector to connect to the control box. The rotor has added bearings to bring it up to Ham M rotor capability.

1 – Ham 4 – parts, includes housing, motor, limit switches, rheostat resistor, gears, ring gear. Would need at least bearings (and maybe other parts) to put into working condition.

TEST EQUIPMENT

2 – Bird Termaline Wattmeters, Model 6104, 25 – 512 MHz range, 60W Termaline Dummy Load Resistor 

5 – Bird slugs, 2-30 MHz  

2 – Bird slugs, 100-250 MHz

 

1 – Tektronix Oscilloscope Model 545A with 2 extra plug-ins (Prefer package deal for all scope components.)

Plug in Model CA 

         Plug-in Model 53/54K 

         Scope cart, wheeled

         Extra tubes for the scope

         Probes for the scope 

  • Heathkit HD-15 Hybrid Phone patch.

1 – Heathkit Digital Frequency Counter, Model IM-2420, 5 Hz to 512 MHz Benchtop Portable Frequency Counter, 4-15 mV sensitivity, two separate inputs and trigger level controls for added versatility. 

1 – Military Signal Generator, SG-103 / URM-25F, .6MHz to 600MHz, with adapters and impedance adapters, test leads. Output level .5 to 100K microvolts, modulation 400 Hz, 1000Hz, variable %Mod level. Heavy duty metal case.

 2 – 50 microamp meters, round

SPARE PARTS

2 – NEW – Heathkit power transformers.  Supposed to be power transformers for SB-102, cannot verify this. No Heath part numbers. 

TUBES

1 – JAN 836          New Old Stock – Unused (JAN 836 Transmitter Half Wave Rectifier Ham Vacuum Tube Hickok TV-7/U Tested  $14.98Pre-owned 

4 – JAN 8020W     New Old Stock – Unused 

4 – JAN 6D4         New Old Stock – Unused  Triode Thyratron Tube

1 – JAN 5651                 New Old Stock – Unused  Voltage Regulator

9 – 5R4                         New Old Stock – Unused  rectifier

6 – 6293                       New Old Stock – Unused  up rated 6146 

 

COAX

1 – Partial spool of RG-214 coax. 50 ohm impedance. Appears to be two sections. Approx. 150 – 200 ft.

1 – partial spool of RG-9 coax with carrier wire. Nominal 51 ohm impedance. (likely used in telecommunications equipment)

1 – Roll of 1 inch hardline, 50 ohm impedance (approx 50 to 100 ft.). Has one connector

 

CABLES

1 – partial spool of rotor cable

2 – Cat 5 network cables, RJ-11 connectors, colored yellow, pink 

1 – partial spool of approx 3/16” stainless steel aircraft cable]

CONNECTORS

2 – 1 inch hardline connectors]

1 – small box of gold connectors (BNC) and small adapters

1 – box of BNC connectors]]

MISC]

2 – Wide spaced, high power variable capacitors.

1 – 160 meter antenna loading coil,]

Misc switches and coax connectors]

Box of assorted ICs (7400 series), crystals, breadboard – prototype circuit boards (new), orange drop capacitors, voltage regulators (7805 etc), disc capacitors. These items are left over from a computer building projects.

1 – Box of 1/2 watt resistors in labeled drawers

1 – Box of 1/4 watt resistors in labeled drawers

1 – roll of 4700 ohm resistors.

 Box of misc components, capacitors, multi-turn pots (circuit board mount). small switches, resistors.

 2 – Toroid forms, may be be ferrite material

1 – spool of 18 ga. Wire

1 – spool of enamel coated transformer wire

1 – Box of hookup wire

1 – Box of voltage regulators, diodes, thermistors]

1 – Computer motherboard,used. Gigabyte 990FA-UD7

WOOD WORKING TOOLS

1 – Mortising machine, Shop Fox Model W1671, 1/2” Chuck, 3/4 H.P., 120 V., (used for one project).

1 – Router table, wooden

1 – ~ 35 ft aluminum Warner extension ladder

 1 – B&D Radial Arm Saw, ~1940’s or 1950’s

1 – Joiner, ~1930s